Broken Coil Spring
Broken Coil Spring can cause clunks, pulling, bouncing, vibration, or unstable handling. Confirm the failed joint, bushing, shock, tire, or alignment problem before replacing suspension parts.
Can I Drive?
fix-soon
Most Likely Causes
- 1
Worn joint or bushing with excessive play
Ball joints, control arm bushings, tie rods, and sway links can clunk or let the car wander.
- 2
Weak shock/strut damping
Worn dampers let the body bounce, float, nose dive, or lose tire control over bumps.
- 3
Tire pressure or alignment problem
Uneven tire pressure or alignment can cause pull, vibration, and uneven tire wear.
- 4
Loose mount or hardware
Loose strut mounts, shock bolts, sway bar brackets, or exhaust hangers can bang over bumps.
As an Amazon Associate, PRJCTX may earn from qualifying purchases. This does not change the price you pay.
How to Diagnose It
- 1
Inspect suspension play safely
Lift the vehicle safely and check for movement at ball joints, tie rods, control arms, sway links, and mounts.
Tool: Jack stands, pry bar
- 2
Bounce and road-test pattern check
Check whether the car continues bouncing after a bump and whether noise happens over one-wheel or two-wheel bumps.
- 3
Check tire pressure, tread, and alignment clues
Compare all tire pressures and look for feathering, edge wear, cupping, or shifted steering wheel.
Tool: Tire gauge
How to Fix It
Replace the confirmed loose joint or bushing
Replace only the part that shows play or damage, then align if steering/suspension geometry changed.
Replace worn shocks or struts in pairs
Replace left/right pairs on the same axle to keep handling balanced.
Correct tire pressure and perform alignment after repairs
Set tire pressure first, repair loose parts, then align the vehicle.
Parts & Tools
Enter your vehicle on the home page to get vehicle-specific parts links.
As an Amazon Associate, PRJCTX may earn from qualifying purchases.
Related Issues
Caliper Piston Seal Leak
A caliper seal leak lets brake fluid escape at the caliper piston, reducing brake pressure and contaminating pads.
Engine Burning Oil No Leak
An engine burning oil no leak means you're losing oil internally through combustion rather than external dripping. This is a serious condition that reduces engine protection and can cause long-term damage if ignored.
Engine Knocking After Oil Change
Engine knocking after oil change usually points to wrong oil viscosity, air bubbles in the system, or a dislodged oil filter. Most issues are fixable without major engine damage if addressed quickly.
Other Suspension Issues
Browse more diagnostic guides in this category.
Alignment Out of Spec
Wheel alignment out of spec means camber, caster, or toe angles are wrong, causing pulling, uneven tire wear, off-center steering, or unstable handling.
Bad Ball Joint
Bad Ball Joint can cause clunks, pulling, bouncing, vibration, or unstable handling. Confirm the failed joint, bushing, shock, tire, or alignment problem before replacing suspension parts.
Bad Ball Joint Symptoms
Bad ball joint symptoms include a clunking noise from the front suspension over bumps, loose or wandering steering, and one-sided edge tire wear. Ball joints are critical safety components — a completely failed ball joint can fold the wheel under the car at highway speed without warning.
Bad CV Axle Joint
Bad CV Axle Joint can cause clunks, pulling, bouncing, vibration, or unstable handling. Confirm the failed joint, bushing, shock, tire, or alignment problem before replacing suspension parts.
Bad Tie Rod End
Bad Tie Rod End can cause clunks, pulling, bouncing, vibration, or unstable handling. Confirm the failed joint, bushing, shock, tire, or alignment problem before replacing suspension parts.
Bad Tie Rod Symptoms
Bad tie rod symptoms include a shaky steering wheel, car pulling to one side, uneven tire wear, and a clunking or knocking sound when turning or hitting bumps. Tie rods connect the steering rack to the front wheels — worn ends allow the wheel to move independently of the steering input.
Mistakes to Avoid
- Do not drive normally with a broken coil spring end near the tire sidewall, brake hose, or strut body.
- Do not replace only one spring if the opposite side is sagging or heavily corroded; ride height and handling can become uneven.
- Do not compress a coil spring without the correct spring compressor and safety procedure.