Cylinder 7 Injector Circuit High
P0280 indicates the fuel injector circuit for cylinder 7 is detecting a higher-than-normal voltage condition. This prevents proper fuel delivery to that cylinder, causing combustion issues and triggering the check engine light. The engine computer has detected an electrical fault in the injector circuit wiring or the injector itself.
What You Might Notice
- Check engine light illuminated
- Rough idle or misfiring
- Poor fuel economy
- Lack of power and hesitation during acceleration
- Possible white or black smoke from exhaust
Most Common Causes
- 1
Faulty fuel injector
The injector for cylinder 7 has failed electrically, causing high resistance or an open circuit in the control signal.
- 2
Damaged injector wiring harness
The electrical connector or wiring to the cylinder 7 injector is corroded, broken, or pinched, preventing proper signal voltage.
- 3
Faulty fuel injector driver module
The engine control module's injector driver circuit for cylinder 7 is malfunctioning, unable to properly control the injector.
- 4
Poor electrical connections
Loose or corroded connections at the fuel injector connector or associated wiring terminals are causing resistance and voltage faults.
How to Diagnose It
- 1
Check Faulty fuel injector — The injector for cylinder 7 has failed electrically, causing high resistance or an open circuit in the control signal.
- 2
Check Damaged injector wiring harness — The electrical connector or wiring to the cylinder 7 injector is corroded, broken, or pinched, preventing proper signal voltage.
- 3
Check Faulty fuel injector driver module — The engine control module's injector driver circuit for cylinder 7 is malfunctioning, unable to properly control the injector.
- 4
Check Poor electrical connections — Loose or corroded connections at the fuel injector connector or associated wiring terminals are causing resistance and voltage faults.
How to Fix It
- 1
Inspect and repair fuel injector wiring
Check the entire wiring harness from the engine control module to the cylinder 7 fuel injector for damage, corrosion, or loose connections. Repair or replace damaged wires and clean corroded connectors.
- 2
Replace fuel injector for cylinder 7
Remove and test the cylinder 7 fuel injector; if it shows high resistance or no continuity, replace it with a new OEM or quality aftermarket injector.
- 3
Test and replace fuel injector driver module
If wiring and injector are good, the engine control module's injector driver circuit may be faulty. Consult technical service bulletins and test with a scope or module tester; replacement may be necessary.
- 4
Clear code and verify repair
After repairs, use a diagnostic scanner to clear the P0280 code and perform a test drive to confirm the rough idle and power loss symptoms are resolved.
Need a deeper diagnosis?
Search for related repair guides or browse by system.