Diesel Intake Air Flow Position Sensor Minimum/Maximum Stop Performance
This code means the PCM/ECM has detected a performance problem affecting diesel intake air flow position sensor minimum/maximum stop. The exact root cause depends on the vehicle, but diagnosis usually starts with scan data, visual inspection, connector checks, and basic circuit testing.
What You Might Notice
- Check Engine Light illuminated
- Reduced performance
- Rough running
- Poor fuel economy
- Intermittent drivability issue
Most Common Causes
- 1
Faulty sensor or actuator
- 2
Wiring or connector problem
- 3
Low voltage or poor ground
- 4
Mechanical issue in the affected system
- 5
PCM/ECM fault
How to Diagnose It
- 1
Check Faulty sensor or actuator — Inspect for signs of failure and test before replacing.
- 2
Check Wiring or connector problem — Inspect for signs of failure and test before replacing.
- 3
Check Low voltage or poor ground — Inspect for signs of failure and test before replacing.
- 4
Check Mechanical issue in the affected system — Inspect for signs of failure and test before replacing.
- 5
Check PCM/ECM fault — Inspect for signs of failure and test before replacing.
How to Fix It
- 1
Verify the fault with a scan tool
- 2
Inspect the affected circuit or component
- 3
Repair wiring, connectors, or grounds as needed
- 4
Replace the failed part if testing confirms it
- 5
Clear the code and retest
Need a deeper diagnosis?
Search for related repair guides or browse by system.