Camshaft Position Sensor "B" Circuit Intermittent (Bank 1)
Code P0369 indicates an intermittent electrical problem with the camshaft position sensor "B" circuit, which monitors valve timing on Bank 1. The engine control module detects sporadic signal loss or voltage fluctuations from this sensor, preventing accurate fuel injection and ignition timing adjustments.
What You Might Notice
- Check Engine Light illuminated
- Intermittent engine bucking or surging
- Engine stalling but immediately restarting
- Rough idle during certain conditions
- Reduced fuel economy
Most Common Causes
- 1
Loose or corroded sensor connector
Poor electrical connections at the camshaft position sensor B connector cause intermittent signal loss. Corrosion or moisture in the connector contacts creates resistance that triggers the code.
- 2
Damaged wiring in sensor circuit
Frayed, pinched, or partially broken wires in the power supply, ground, or signal lines to sensor B create intermittent open or short conditions. Vibration and engine heat can gradually worsen wire insulation.
- 3
Failing camshaft position sensor B
The sensor itself may be failing internally, producing intermittent signal dropout or erratic voltage output. Temperature-dependent failures are common as the sensor heats and cools.
- 4
PCM or wiring harness fault
Intermittent faults in the powertrain control module's sensor input circuit or corroded grounds in the engine harness can cause sporadic signal detection issues.
How to Diagnose It
- 1
Check Loose or corroded sensor connector — Poor electrical connections at the camshaft position sensor B connector cause intermittent signal loss. Corrosion or moisture in the connector contacts creates resistance that triggers the code.
- 2
Check Damaged wiring in sensor circuit — Frayed, pinched, or partially broken wires in the power supply, ground, or signal lines to sensor B create intermittent open or short conditions. Vibration and engine heat can gradually worsen wire insulation.
- 3
Check Failing camshaft position sensor B — The sensor itself may be failing internally, producing intermittent signal dropout or erratic voltage output. Temperature-dependent failures are common as the sensor heats and cools.
- 4
Check PCM or wiring harness fault — Intermittent faults in the powertrain control module's sensor input circuit or corroded grounds in the engine harness can cause sporadic signal detection issues.
How to Fix It
- 1
Inspect and clean sensor connector
Locate the camshaft position sensor B connector on Bank 1, disconnect it, and clean both the connector pins and socket with electrical contact cleaner. Reinstall firmly and test for code clearance.
- 2
Check and repair wiring harness
Visually inspect the entire wiring harness from the sensor to the PCM for cuts, abrasions, or loose connections. Repair or replace damaged sections of wire using proper automotive-grade connectors and solder.
- 3
Replace camshaft position sensor B
Remove the faulty camshaft position sensor B using appropriate sockets and wrenches. Install a new OEM or quality aftermarket sensor, torque to specification, and reconnect the harness.
- 4
Test PCM and grounds
If code persists after sensor and wiring repairs, use a multimeter to check ground connections at the engine block and PCM. Test PCM voltage supply and sensor input circuits with a diagnostic scanner to identify module faults.
Need a deeper diagnosis?
Search for related repair guides or browse by system.