Cruise Control Coast Signal Malfunction
Code P0569 indicates the cruise control system has detected a malfunction in the coast function signal circuit. This signal tells the vehicle when the driver wants to slow down while cruise control is active, and a fault here prevents proper cruise control operation.
What You Might Notice
- Cruise control light not illuminating or stays on constantly
- Cruise control system completely inoperative
- Unable to set or maintain desired cruise control speed
- Coast function (deceleration) not working while in cruise control mode
- Erratic or unstable cruise control speed behavior
Most Common Causes
- 1
Defective cruise control switch
The coast button or switch contacts within the steering wheel cruise control assembly have failed or are worn out, preventing proper signal transmission to the ECM.
- 2
Damaged wiring or connector corrosion
Wires in the cruise control harness are chafed, broken, or corroded connectors are preventing proper electrical connection between the switch and control module.
- 3
Liquid contamination of switch assembly
The cruise control switch has been exposed to moisture or liquids (coffee, soda, etc.) causing internal corrosion and electrical shorts or opens.
- 4
ECM or control module issue
The engine control module has developed a fault in the cruise control circuit processing or is not receiving the coast signal input correctly.
How to Diagnose It
- 1
Check Defective cruise control switch — The coast button or switch contacts within the steering wheel cruise control assembly have failed or are worn out, preventing proper signal transmission to the ECM.
- 2
Check Damaged wiring or connector corrosion — Wires in the cruise control harness are chafed, broken, or corroded connectors are preventing proper electrical connection between the switch and control module.
- 3
Check Liquid contamination of switch assembly — The cruise control switch has been exposed to moisture or liquids (coffee, soda, etc.) causing internal corrosion and electrical shorts or opens.
- 4
Check ECM or control module issue — The engine control module has developed a fault in the cruise control circuit processing or is not receiving the coast signal input correctly.
How to Fix It
- 1
Inspect and clean cruise control switch
Remove the steering wheel cruise control switch assembly and inspect for visible damage, corrosion, or contamination. Clean with electronics cleaner if contaminated, or replace if damaged.
- 2
Check cruise control wiring and connectors
Inspect the entire cruise control harness from the steering wheel switch to the ECM for chafed insulation, breaks, or bent pins. Test connector continuity with a multimeter and repair or replace damaged sections.
- 3
Replace faulty cruise control switch
If inspection reveals internal switch failure or contamination that cannot be cleaned, replace the entire steering wheel cruise control switch assembly with a new unit.
- 4
Diagnose ECM or reprogram module
If wiring and switches test good, have the ECM scanned for internal faults or reprrogrammed. In rare cases, the control module may need replacement.
Need a deeper diagnosis?
Search for related repair guides or browse by system.