Cruise Control Input Circuit Low
The P0576 code indicates the ECM detected a low voltage condition in the cruise control input circuit. This prevents the cruise control system from functioning properly and activating when requested by the driver.
What You Might Notice
- Cruise control system does not engage or respond
- Check engine light (CEL) illuminated on dashboard
- Cruise control buttons unresponsive when pressed
- Loss of cruise control functionality across all speeds
- Possible intermittent cruise control operation
Most Common Causes
- 1
Defective cruise control switch
The cruise control buttons or main switch assembly may be worn, damaged, or internally shorted, causing low voltage in the input circuit.
- 2
Wiring issues or corrosion
Damaged, corroded, or disconnected wiring in the cruise control circuit can create resistance and cause voltage to drop below acceptable levels.
- 3
Poor electrical connector contact
Loose, corroded, or improperly seated connectors in the cruise control circuit can prevent proper voltage transmission to the ECM.
- 4
ECM or module malfunction
A faulty engine control module or cruise control module may incorrectly interpret normal voltage as low, though this is less common than switch/wiring issues.
How to Diagnose It
- 1
Check Defective cruise control switch — The cruise control buttons or main switch assembly may be worn, damaged, or internally shorted, causing low voltage in the input circuit.
- 2
Check Wiring issues or corrosion — Damaged, corroded, or disconnected wiring in the cruise control circuit can create resistance and cause voltage to drop below acceptable levels.
- 3
Check Poor electrical connector contact — Loose, corroded, or improperly seated connectors in the cruise control circuit can prevent proper voltage transmission to the ECM.
- 4
Check ECM or module malfunction — A faulty engine control module or cruise control module may incorrectly interpret normal voltage as low, though this is less common than switch/wiring issues.
How to Fix It
- 1
Inspect and test cruise control switches
Examine the cruise control buttons and switches on the steering wheel for damage or wear. Use a multimeter to test for proper voltage and resistance values. Replace if defective.
- 2
Check wiring and connectors
Inspect the cruise control circuit wiring for damage, corrosion, or pinching. Verify all connectors are clean, properly seated, and making good contact. Clean or replace connectors as needed.
- 3
Clean or repair corroded connections
Remove corrosion from connector pins and wiring terminals using electrical contact cleaner or fine sandpaper. Apply dielectric grease to prevent future corrosion.
- 4
Replace cruise control switch if faulty
If testing confirms the cruise control switch is defective, replace the entire switch assembly. This is typically a bolt-on replacement requiring removal of steering wheel trim.
Need a deeper diagnosis?
Search for related repair guides or browse by system.