Cruise Control Vacuum Control Circuit /Open
P0582 indicates an open or faulty circuit in the cruise control vacuum control system. This code sets when the engine control module detects a break in the electrical circuit that controls the vacuum solenoid or servo responsible for maintaining cruise control speed.
What You Might Notice
- Cruise control inoperative or won't engage
- Check engine light (CEL) illuminated
- Cruise control set/resume/accelerate functions not working
- Vehicle speed varies unexpectedly even with cruise control set
- Cruise control indicator light stays on permanently
Most Common Causes
- 1
Faulty cruise control vacuum solenoid
The solenoid that controls vacuum flow to the cruise control servo may be stuck open, failed electrically, or have an internal blockage preventing proper operation.
- 2
Open or damaged wiring in cruise control circuit
Broken, corroded, or disconnected wiring between the ECM and the cruise control solenoid creates an open circuit that prevents voltage from reaching the component.
- 3
Defective cruise control servo
In systems where cruise control vacuum responsibilities are consolidated to the servo, a failed servo prevents the system from maintaining set speed.
- 4
Corroded connectors or poor electrical connections
Oxidation or loose connectors at the solenoid, servo, or ECM reduce electrical conductivity and trigger the open circuit fault.
How to Diagnose It
- 1
Check Faulty cruise control vacuum solenoid — The solenoid that controls vacuum flow to the cruise control servo may be stuck open, failed electrically, or have an internal blockage preventing proper operation.
- 2
Check Open or damaged wiring in cruise control circuit — Broken, corroded, or disconnected wiring between the ECM and the cruise control solenoid creates an open circuit that prevents voltage from reaching the component.
- 3
Check Defective cruise control servo — In systems where cruise control vacuum responsibilities are consolidated to the servo, a failed servo prevents the system from maintaining set speed.
- 4
Check Corroded connectors or poor electrical connections — Oxidation or loose connectors at the solenoid, servo, or ECM reduce electrical conductivity and trigger the open circuit fault.
How to Fix It
- 1
Inspect and repair cruise control wiring
Check the complete wiring harness between the ECM and cruise control solenoid/servo for breaks, corrosion, or loose connections. Repair or replace damaged sections and reconnect loose connectors securely.
- 2
Replace cruise control vacuum solenoid
Test the solenoid with a multimeter for continuity and resistance values. If faulty, remove and install a new OEM or quality replacement solenoid.
- 3
Replace cruise control servo
If the servo is integrated with vacuum control and testing confirms it is faulty, unbolt the old servo from its mounting location and install a replacement unit.
- 4
Clean or replace corroded connectors
Remove corrosion from connector terminals using a wire brush or contact cleaner. If damage is severe, replace the entire connector assembly to restore proper electrical contact.
Need a deeper diagnosis?
Search for related repair guides or browse by system.