Internal Control Module Ignition Coil Control Performance
This code means the PCM/ECM has detected a performance problem affecting internal control module ignition coil control. Because combustion on the affected cylinder or circuit is disrupted, drivers may notice rough running, misfires, hard starts, or reduced power.
What You Might Notice
- Check Engine Light illuminated
- Rough idle or misfire
- Hard starting
- Reduced power
- Poor fuel economy
Most Common Causes
- 1
Failed ignition coil, glow plug, or related component
- 2
Damaged wiring or poor connector contact
- 3
Worn spark plug or combustion problem
- 4
Low system voltage or ground issue
- 5
PCM/ECM driver fault
How to Diagnose It
- 1
Check Failed ignition coil, glow plug, or related component — Inspect for signs of failure and test before replacing.
- 2
Check Damaged wiring or poor connector contact — Inspect for signs of failure and test before replacing.
- 3
Check Worn spark plug or combustion problem — Inspect for signs of failure and test before replacing.
- 4
Check Low system voltage or ground issue — Inspect for signs of failure and test before replacing.
- 5
Check PCM/ECM driver fault — Inspect for signs of failure and test before replacing.
How to Fix It
- 1
Test the affected coil, glow plug, or ignition-related component
- 2
Inspect spark plugs and basic engine condition
- 3
Repair damaged wiring, grounds, or connector pins
- 4
Replace the failed ignition-related part
- 5
Clear the code and confirm the symptom is gone
Need a deeper diagnosis?
Search for related repair guides or browse by system.