Throttle Actuator Control Module Processor
The PCM (Powertrain Control Module) has detected a processor fault in the throttle actuator control system, causing the engine to enter failsafe or limp mode. This severely restricts throttle response and engine operation as a safety measure to prevent uncontrolled acceleration.
What You Might Notice
- Engine will not start or starts with difficulty
- Little to no throttle response when pressing accelerator
- Engine held at idle speed with poor acceleration
- Check Engine Light illuminated
- Smoke from tailpipe and increased fuel consumption
Most Common Causes
- 1
Throttle Actuator Control Module Failure
The electronic throttle control module processor has malfunctioned or failed internally. This is the most direct cause of P2107.
- 2
PCM Software Corruption or Update Issue
The PCM firmware or software has become corrupted, or a failed update has damaged the processor code. Reprogramming may be required.
- 3
Wiring or Connector Issues to Throttle Control
Damaged wiring, loose connectors, or corroded pins between the PCM and throttle actuator prevent proper signal communication.
- 4
Power Supply or Voltage Problems to PCM
Insufficient voltage, battery issues, or alternator failure prevent the PCM processor from operating correctly.
How to Diagnose It
- 1
Check Throttle Actuator Control Module Failure — The electronic throttle control module processor has malfunctioned or failed internally. This is the most direct cause of P2107.
- 2
Check PCM Software Corruption or Update Issue — The PCM firmware or software has become corrupted, or a failed update has damaged the processor code. Reprogramming may be required.
- 3
Check Wiring or Connector Issues to Throttle Control — Damaged wiring, loose connectors, or corroded pins between the PCM and throttle actuator prevent proper signal communication.
- 4
Check Power Supply or Voltage Problems to PCM — Insufficient voltage, battery issues, or alternator failure prevent the PCM processor from operating correctly.
How to Fix It
- 1
Scan and Reprogram PCM
Connect to the vehicle with a professional diagnostic scanner and attempt to reprogram or reflash the PCM with the latest software version. This resolves many processor-related faults.
- 2
Inspect Throttle Control Wiring and Connectors
Visually inspect all wiring harnesses and connectors between the PCM, throttle body, and related sensors for damage, corrosion, or loose connections. Repair or replace as needed.
- 3
Test and Replace Throttle Actuator Control Module
If reprogramming fails, the throttle actuator control module itself may have failed hardware. Test with a known-good module or replace the unit.
- 4
Replace PCM if Processor Damage Confirmed
If the processor is internally damaged and cannot be reprogrammed, the entire PCM must be replaced and reprogrammed with vehicle-specific calibration data.
Need a deeper diagnosis?
Search for related repair guides or browse by system.