Water in Fuel Sensor Circuit
P2264 indicates a malfunction in the water-in-fuel sensor circuit, which detects contamination in the fuel system. This code sets when the sensor fails to communicate properly with the engine control module, preventing detection of water that can damage fuel injectors and the engine.
What You Might Notice
- Engine stalling or hesitation during acceleration
- Severe misfiring and rough idle
- Engine will not start or hard starting
- Poor fuel economy and reduced performance
- Check engine light and water-in-fuel warning light illuminated
Most Common Causes
- 1
Defective water-in-fuel sensor
The sensor itself has failed electrically or mechanically and cannot detect fuel contamination or transmit a signal to the ECU.
- 2
Contaminated fuel with water
Actual water in the fuel tank has triggered the sensor, indicating fuel system contamination from moisture ingress or poor fuel quality.
- 3
Corroded or damaged connector or wiring
Corrosion, loose connections, or damaged wiring between the sensor and ECU prevents proper signal transmission.
- 4
Faulty fuel filter or blown fuse
A clogged fuel filter or blown fuse in the sensor circuit can cause sensor malfunction or lack of power to the sensor.
How to Diagnose It
- 1
Check Defective water-in-fuel sensor — The sensor itself has failed electrically or mechanically and cannot detect fuel contamination or transmit a signal to the ECU.
- 2
Check Contaminated fuel with water — Actual water in the fuel tank has triggered the sensor, indicating fuel system contamination from moisture ingress or poor fuel quality.
- 3
Check Corroded or damaged connector or wiring — Corrosion, loose connections, or damaged wiring between the sensor and ECU prevents proper signal transmission.
- 4
Check Faulty fuel filter or blown fuse — A clogged fuel filter or blown fuse in the sensor circuit can cause sensor malfunction or lack of power to the sensor.
How to Fix It
- 1
Inspect and replace water-in-fuel sensor
Locate the sensor (typically in the fuel filter housing or tank area), test its electrical resistance, and replace if defective. Ensure the fuel tank is drained before removal.
- 2
Drain contaminated fuel and refill
If water is present in the fuel, drain the entire fuel tank and replace with fresh, clean fuel. Consider replacing the fuel filter to remove any residual contamination.
- 3
Check and repair connector and wiring
Inspect the sensor connector for corrosion or loose pins. Clean corroded terminals with electrical contact cleaner, repair any damaged wiring, and ensure all connections are secure.
- 4
Verify fuse and power supply
Check the fuel sensor fuse in the fuse box and replace if blown. Test voltage at the sensor connector to confirm proper power supply from the ECU.
Need a deeper diagnosis?
Search for related repair guides or browse by system.