Diesel Particulate Filter Pressure Sensor "B" Circuit Range/Performance
This code means the PCM/ECM has detected a circuit performance problem affecting diesel particulate filter pressure sensor "b. This can keep the emissions system from working correctly, which may raise tailpipe emissions, reduce fuel economy, and prevent readiness monitors from completing.
What You Might Notice
- Check Engine Light illuminated
- Reduced fuel economy
- Failed emissions or readiness monitor
- Rough idle or hesitation
- Possible exhaust smell or smoke
Most Common Causes
- 1
Failed sensor, valve, heater, or emissions actuator
- 2
Wiring damage or poor electrical connection
- 3
Carbon buildup, restriction, or exhaust leak
- 4
Vacuum leak or pressure hose issue
- 5
PCM/ECM fault or outdated calibration
How to Diagnose It
- 1
Check Failed sensor, valve, heater, or emissions actuator — Inspect for signs of failure and test before replacing.
- 2
Check Wiring damage or poor electrical connection — Inspect for signs of failure and test before replacing.
- 3
Check Carbon buildup, restriction, or exhaust leak — Inspect for signs of failure and test before replacing.
- 4
Check Vacuum leak or pressure hose issue — Inspect for signs of failure and test before replacing.
- 5
Check PCM/ECM fault or outdated calibration — Inspect for signs of failure and test before replacing.
How to Fix It
- 1
Inspect the sensor, valve, heater, and related hoses or pipes
- 2
Repair wiring or connector damage
- 3
Clean carbon buildup or repair leaks/restrictions
- 4
Replace the failed emissions component if testing confirms it
- 5
Clear the code and run the monitor to verify the fix
Need a deeper diagnosis?
Search for related repair guides or browse by system.