Intermediate Shaft Speed Sensor C Circuit Range/Performance
P2750 indicates the transmission control module has detected a malfunction in the intermediate shaft speed sensor C circuit, meaning the sensor signal is out of range or not performing correctly. This sensor provides critical feedback about transmission shaft speed for proper shift timing and transmission control.
What You Might Notice
- Hard or delayed gear shifts
- Check Engine Light and transmission warning lights illuminated
- Poor vehicle driveability and acceleration
- Erratic engine speed or RPM fluctuations
- Transmission may enter limp mode or default gear
Most Common Causes
- 1
Defective intermediate shaft speed sensor
The sensor itself may be damaged, worn, or failing and unable to generate proper signal voltage. This is the most common cause of this code.
- 2
Wiring or connector fault
Broken, corroded, or loose wiring between the speed sensor and transmission control module prevents proper signal transmission. Check connectors for corrosion and wires for damage.
- 3
Dirty or low transmission fluid
Contaminated or insufficient automatic transmission fluid can affect sensor operation and overall transmission performance. Low fluid level reduces hydraulic pressure needed for proper shifting.
- 4
Transmission control module (TCM) malfunction
Internal ECM/TCM failure or software corruption may cause the module to misinterpret valid sensor signals or fail to communicate with the sensor circuit properly.
How to Diagnose It
- 1
Check Defective intermediate shaft speed sensor — The sensor itself may be damaged, worn, or failing and unable to generate proper signal voltage. This is the most common cause of this code.
- 2
Check Wiring or connector fault — Broken, corroded, or loose wiring between the speed sensor and transmission control module prevents proper signal transmission. Check connectors for corrosion and wires for damage.
- 3
Check Dirty or low transmission fluid — Contaminated or insufficient automatic transmission fluid can affect sensor operation and overall transmission performance. Low fluid level reduces hydraulic pressure needed for proper shifting.
- 4
Check Transmission control module (TCM) malfunction — Internal ECM/TCM failure or software corruption may cause the module to misinterpret valid sensor signals or fail to communicate with the sensor circuit properly.
How to Fix It
- 1
Replace intermediate shaft speed sensor
Locate the sensor on the transmission, disconnect the electrical connector, remove the sensor mounting bolt, and install a new OEM or quality replacement sensor. Reconnect the connector securely and clear the code.
- 2
Inspect and repair wiring harness
Visually inspect the wiring from the sensor to the TCM for cuts, corrosion, or loose connections. Clean corroded connectors with electrical contact cleaner, repair damaged wires, and ensure all connections are tight.
- 3
Check and service transmission fluid
Verify transmission fluid level is correct and the fluid color is red (not brown or burnt smelling). If low, top up; if dirty or burnt, perform a transmission fluid and filter change to restore proper transmission operation.
- 4
Reprogram or replace transmission control module
If wiring and sensor are confirmed functional, the TCM may need reprogramming with the latest software or replacement if internal failure is detected. This requires specialized diagnostic equipment and should be performed by a qualified technician.
Need a deeper diagnosis?
Search for related repair guides or browse by system.