Pressure Control Solenoid "H" Control Circuit Range/Performance
This code means the PCM/ECM has detected a control circuit performance problem affecting pressure control solenoid "h. The exact root cause depends on the vehicle, but diagnosis usually starts with scan data, visual inspection, connector checks, and basic circuit testing.
What You Might Notice
- Check Engine Light illuminated
- Reduced performance
- Rough running
- Poor fuel economy
- Intermittent drivability issue
Most Common Causes
- 1
Faulty sensor or actuator
- 2
Wiring or connector problem
- 3
Low voltage or poor ground
- 4
Mechanical issue in the affected system
- 5
PCM/ECM fault
How to Diagnose It
- 1
Check Faulty sensor or actuator — Inspect for signs of failure and test before replacing.
- 2
Check Wiring or connector problem — Inspect for signs of failure and test before replacing.
- 3
Check Low voltage or poor ground — Inspect for signs of failure and test before replacing.
- 4
Check Mechanical issue in the affected system — Inspect for signs of failure and test before replacing.
- 5
Check PCM/ECM fault — Inspect for signs of failure and test before replacing.
How to Fix It
- 1
Verify the fault with a scan tool
- 2
Inspect the affected circuit or component
- 3
Repair wiring, connectors, or grounds as needed
- 4
Replace the failed part if testing confirms it
- 5
Clear the code and retest
Need a deeper diagnosis?
Search for related repair guides or browse by system.